Signal Ground. Must be connected to maintain signal integrity and prevent electrical noise. Throttle Range Calibration
Connect the three wires from the brushless motor to the three output wires of the ESC. If the motor spins in the wrong direction, swapping any two of these three connections is a standard troubleshooting step.
The manual wasn't just a guide; it was the silent co-pilot that turned a pile of parts into a champion.
Plug the ESC's 3-wire BEC cable into Channel 2 (CH2) of your receiver. brushless esc v2.3 manual
You can program the ESC using one of two methods: the or a dedicated LED Program Card (strongly recommended).
If the motor starts spinning immediately upon battery connection, you missed step 3. Repeat carefully.
Typically compatible with 2–3S LiPo or 4–9 cell Ni-MH batteries. Signal Ground
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
Alex was impatient. He plugged the battery in immediately.
Immediately move the throttle stick to the position. If the motor spins in the wrong direction,
leave a connected battery unattended inside your vehicle or model.
If you want, I can produce: a one‑page quickstart sheet, a troubleshooting flowchart, or the printable programming table for v2.3.
Maximum protection for premium LiPo batteries. 5. Motor Timing
The V2.3 firmware allows users to customize several operational parameters using either a transmitter stick sequence or a dedicated LED programming card. 1. Brake Setting
MyBB has experienced an internal SQL error and cannot continue.
